Electronic Theatre Controls Sensor User Manual download pdf (Page 35)

4 CEM+ Configuration Procedures 30

Chapter 4

CEM+ Configuration Procedures

CEM+ Configuration Overview

Configuring a CEM+ from either the face panel via the LCD and buttons or the Sensor+

Connect web interface are basically the same procedures done in the same order. The web

interface is more intuitive and you are able to make more changes simultaneously; making

it a more efficient way to configure the modules.

Please refer to the LCD menu structures and web interface site map for navigation details.

Since there are nearly an infinite number (at least for practical purposes of counting them)

of ways for you to configure your racks and dimmers, the procedures in this section are

intended to be building blocks for you to use to configure your unique system.

The headings for each procedure will contain either a [Power], [User] or a [Guest] to

denote the minimum required access level. [Web] or [FP] will note whether a specific

navigation path is for the web interface or the CEM+ face panel.

Configuration Procedures

Configure Your Computer for an ETCNet2 Network

Prior to changing any Network settings on your personal computer please record the

current settings in the following spaces below.

To use your personal computer on an ETCNet2 network that does not use a network router

(i.e. hub and/or switch only), ETC recommends the following default settings:

Note:

If you are setting this computer up to be an FTP server, then you should set the IP

address to 10.101.101.117 —the default FTP server IP address of CEM+ modules.

If you have a network that does include a network router, you must set the Gateway IP

address to the appropriate port on the router.

Each additional computer on an ETCNet2 network must have it’s own IP address which

must be different from any other computer on the same ETCNet2 network. Select from the

following default range of IP addresses for an additional personal computer on the network:

• 10.101.1.101 thru 10.101.1.249

IP Address _____._____._____._____

Subnet Mask _____._____._____._____

Gateway IP _____._____._____._____

IP Address 10.101.1.101

Subnet Mask 255.255.0.0

Gateway IP 10.101.1.101

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 75 76

No comments

Electronic Theatre Controls Sensor User Manual Page 35