Electronic Theatre Controls Sensor User Manual download pdf (Page 40)

35 Sensor+ CEM+ Configuration Manual

advanced patch mode, however dimmers are not actually in dimmer doubling mode unless

they are set with a Dimmer Double firing mode.

It’s worth restating, that Standard Patch and Advanced Patch are handled as two

completely separate patches including port enables, priorities and data loss behaviors. This

means that if you configure the ports while in standard patch mode, switching to advanced

patch mode will also switch those ports enables and data loss behaviors to a different

configuration.

Set Dimmer Properties

When a rack initially gets defined, it contains the default dimmer type with default properties

throughout the rack. If you have a mix of dimmer types in a rack, you need to configure

those after the racks have been added to the group.

You can either edit the dimmer properties (dimmer type, fire mode, voltage regulation...)

individually, or by searching for dimmers by several criteria and edit those found dimmers

at the same time.

For specific dimmer configurations:

Switched

Change the firing mode to Switched and click Save Changes. After saving changes, the

remaining dimmer properties will change automatically or can now be set to your desired

values. Currently when Switched firing mode is selected, all other properties for that dimmer

are ignored.

Non-Dim

Change the firing mode to Normal and click Save Changes. After saving changes, make

the remaining changes to the dimmer properties as listed below. Currently, setting the firing

Property

120V 230V

Firing Mode Switched Switched

Curve Linear Linear

Threshold 1% 1%

Min. Scale Voltage 140V 265V

Max. Scale Voltage 140V 265V

Voltage Regulation Unchecked Unchecked

Preheat Unchecked Unchecked

Dynamic Preheat 0 sec. 0 sec.

DC Output Prevent Unchecked Unchecked

InRush Protect Unchecked Unchecked

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 75 76

No comments

Electronic Theatre Controls Sensor User Manual Page 40