Electronic Theatre Controls Express 24/48 User Manual download pdf (Page 9)

2 User Manual Supplement - Expression/Express consoles

Enable the Moving Lights Module (and simultaneously disable the

Designer Worksheet function) with the following procedure:

1. Switch on the console power.

2. Press [Setup] [6], Option Settings, [Enter] to go to the Options Set-

tings menu.

3. Press [1][2], External Port, [Enter].

4. Press [2] [Enter] to enable the Moving Light Module

Pointing device installation

You may attach a pointing device, such as a mouse, trackball or trackpad

to the Moving Lights Module. Switch off the power to the console and to

the Moving Lights Module. Connect the mouse or trackball to the appro-

priately labeled RS 232 port on the Moving Lights Module. The pointing

device must be Microsoft-compatible.

Device check

The pointing device should be ready for use when the console and module

are switched on. Verify normal operation by patching fixtures as explained

under Working with Moving Lights, page 16. Movement of the pointing

device should control pan and tilt levels; its buttons should reselect fix-

tures in the Fixture Box window. If the device doesn’t function normally,

proceed as follows:

1. Verify that the pointing device is Microsoft compatible.

2. Verify that the pointing device works normally in another system, such

as in a computer.

3. If steps 1 and 2 don’t correct the problem, call ETC Technical Service

at 800-775-4382.

If you later decide to connect a digitizer to the console rather than the

Moving Lights Module, you must enable the digitizer by pressing [1]

in this step of the procedure.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 76 77

No comments

Electronic Theatre Controls Express 24/48 User Manual Page 9