Electronic Theatre Controls Source Four Revolution User Manual download pdf (Page 43)

Routine Maintenance 39

Internal Test Software

The following diagnostic tests are available using the thumbwheels on your Source Four

Revolution fixture. To run a test, set the address to the desired test (tests may be run at any

time). The green LED will blink rapidly to indicate the fixture is in self-test mode and the

fixture will not respond to incoming DMX signal. To return the fixture to DMX operation, set

the thumbwheel back to a valid DMX start address.

Test Description Address Notes or Test Parameter (#)

HOLD 800

All open, Pan & Tilt @ 50%, Intensity @ 75% 8 0 1

SLOW fade all from 0-100% 8 0 2 20 seconds; continuous cycle.

MED fade all from 0-100% 8 0 3 10 seconds; continuous cycle.

FAST fade all from 0-100% 8 0 4

Bounce; some attributes may not complete their full

range of motion.

16 predefined cues run sequentially 8 0 5 5 seconds between cues.

Pan and Tilt motors disabled 8 0 6 NOTE: Cycle power to return to normal operation.

Bypass Calibration 8 0 7 Start-up at this address to skip calibration.

Fade parameters 0-100%, Intensity @ 8 0 8

Bounce; some attributes may not complete their full

range of motion.

HOLD 809

Dimmer (tests 815-819 do not apply) 8 1 #

Use the parameter numbers below in the (#) position

of the test address to change the behavior of the

tests. Example: test 825 moves the Pan motor from

end stop to end stop at a slow speed. Test 826

performs the same movement, but at medium speed.

Pan 82#

Tilt 8 3 #

Front Bay (Iris or Wheel modules) 8 4 #

Rear Bay (Iris or Wheel modules) 8 5 #

Scroller 8 6 #

0 = HOLD

Wheel Function (operates both bays) 8 8 #

1 = Increment (0-100%)

Wheel Index/Rotate (operates both bays) 8 9 #

2 = Decrement (100-0%)

Shutter #1 In/Out 9 0 #

3 = HOLD

Shutter #1 Rotate 9 1 #

4 = Invert (if on, fade to 0, if off, fade to full)

Shutter #2 In/Out 9 2 #

5 = SLOW fade from 0-100%, continuous cycle

Shutter #2 Rotate 9 3 #

6 = MED fade from 0-100%, continuous cycle

Shutter #3 In/Out 9 4 #

7 = FAST fade from 0-100%, continuous cycle

Shutter #3 Rotate 9 5 #

8 = Incremental fade from 0-100% of selected in 10%

increments in 1 second timing, continuous cycle

Shutter #4 In/Out 9 6 #

Shutter #4 Rotate 9 7 #

9 = Incremental fade from 0-100% of attribute in 25%

increments in 2 second timing, continuous cycle

Rotate All Shutters 9 8 #

Lenses and Internal Media Frame 8 7 #

0 = HOLD

1 = Increment Zoom (0-100%)

2 = Decrement Zoom (100-0%)

3 = HOLD

4 = Increment Focus (0-100%)

5 = Decrement Focus (100-0%)

6 = HOLD

7 = IMF In/Out (toggles state of IMF)

8 = Incremental Zoom from 0-100% in 10 second

timing, continuous cycle

9 = Incremental Focus from 0-100% in 10 second

timing, continuous cycle

1 2 ... 38 39 40 41 42 43 44 45 46 47 48

Comments to this Manuals

No comments

Electronic Theatre Controls Source Four Revolution User Manual Page 43

Comments to this Manuals

Related products and manuals for Floodlights Electronic Theatre Controls Source Four Revolution