Electronic Theatre Controls Source Four Revolution User Manual download pdf (Page 8)

4 Source Four Revolution User Manual

Installation

Power and Data cabling requirements

The Source Four Revolution fixture operates on AC power, 100-240VAC/50-60Hz, and

consumes a maximum of 900 watts. You may use a circuit powered through an SCR

dimmer, as long as the dimmer is set to unregulated non-dim (switched) operation.

The Source Four Revolution operates on DMX control signal. The unit is supplied with a

5-pin XLR DMX input connector and a 5-pin DMX Thru connector. DMX cables should be

acceptable for DMX data transmission (not microphone cable) and should follow the

standard pinout. The optional secondary data pair is not used by the Source Four

Revolution fixture. On pre-2007 fixtures, termination is required after the last fixture on a

DMX data line. Revolutions built in 2007 or later are equipped with self-terminating

connectors.

DMX512 pinout for five-pin XLR female

1 Common (Shield)

2 Data –

3 Data +

4 not connected

5 not connected

Push

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 47 48

No comments

Electronic Theatre Controls Source Four Revolution User Manual Page 8